Sale!
Variable Speed Drives
ATV310HU55N4E Variable speed drive ATV310, 5.5 kW, 7.5 hp, 380…460 V, 3 phase
Original price was: ₦728,683.63.₦582,946.90Current price is: ₦582,946.90. 7.5% VAT
Variable speed drive ATV310, 5.5 kW, 7.5 hp, 380…460 V, 3 phase
| range of product |
Easy Altivar 310
|
|
|---|---|---|
| product or component type |
Variable speed drive
|
|
| product specific application |
Simple machine
|
|
| assembly style |
With heat sink
|
|
| device short name |
ATV310
|
|
| network number of phases |
Three phase
|
|
| [Us] rated supply voltage |
380…460 V – 15…10 %
|
|
| motor power kW |
5.5 kW
|
|
| motor power hp |
7.5 hp
|
|
| noise level |
50 dB
|
| product destination |
Asynchronous motors
|
|
|---|---|---|
| Quantity per set |
Set of 1
|
|
| EMC filter |
Without EMC filter
|
|
| type of cooling |
Integrated fan
|
|
| supply frequency |
50/60 Hz +/- 5 %
|
|
| communication port protocol |
Modbus
|
|
| connector type |
RJ45 (on front face) for Modbus
|
|
| physical interface |
2-wire RS 485 for Modbus
|
|
| transmission frame |
RTU for Modbus
|
|
| transmission rate |
4800 bit/s
9600 bit/s 19200 bit/s 38400 bit/s |
|
| number of addresses |
1…247 for Modbus
|
|
| communication service |
Read holding registers (03) 29 words
Write single register (06) 29 words Write multiple registers (16) 27 words Read/write multiple registers (23) 4/4 words Read device identification (43) |
|
| line current |
14.3 A
|
|
| apparent power |
11.4 kVA
|
|
| prospective line Isc |
5 kA
|
|
| continuous output current |
12.6 A at 4 kHz
|
|
| maximum transient current |
18.9 A for 60 s
|
|
| power dissipation in W |
141.54 W at In
|
|
| speed drive output frequency |
0.5…400 Hz
|
|
| nominal switching frequency |
4 kHz
|
|
| switching frequency |
2…12 kHz adjustable
|
|
| speed range |
1…20
|
|
| transient overtorque |
170…200 % of nominal motor torque depending on drive rating and type of motor
|
|
| braking torque |
Up to 150 % of nominal motor torque with braking resistor at high inertia
Up to 70 % of nominal motor torque without braking resistor |
|
| asynchronous motor control profile |
Energy saving ratio
Energy saving ratio Quadratic voltage/frequency ratio |
|
| motor slip compensation |
Adjustable
Preset in factory |
|
| output voltage |
380…460 V three phase
|
|
| electrical connection |
Terminal, clamping capacity: 4 mm² (L1, L2, L3, PA/+, PB, U, V, W)
|
|
| tightening torque |
1.2…1.4 N.m
|
|
| insulation |
Electrical between power and control
|
|
| supply |
Internal supply for reference potentiometer: 5 V (4.75…5.25 V)DC, <10 mA with overload and short-circuit protection
Internal supply for logic inputs: 24 V (20.4…28.8 V)DC, <100 mA with overload and short-circuit protection |
|
| analogue input number |
1
|
|
| analogue input type |
Configurable current AI1 0…20 mA 250 Ohm
Configurable voltage AI1 0…10 V 30 kOhm Configurable voltage AI1 0…5 V 30 kOhm |
|
| discrete input number |
4
|
|
| discrete input type |
Programmable LI1…LI4 24 V 18…30 V
|
|
| discrete input logic |
Negative logic (sink), > 16 V (state 0), < 10 V (state 1), input impedance 3.5 kOhm
Positive logic (source), 0…< 5 V (state 0), > 11 V (state 1) |
|
| sampling duration |
10 ms for analogue input
20 ms, tolerance +/- 1 ms for logic input |
|
| linearity error |
+/- 0.3 % of maximum value for analogue input
|
|
| analogue output number |
1
|
|
| analogue output type |
AO1 software-configurable voltage: 0…10 V, impedance: 470 Ohm, resolution 8 bits
AO1 software-configurable current: 0…20 mA, impedance: 800 Ohm, resolution 8 bits |
|
| discrete output number |
2
|
|
| discrete output type |
Logic output LO+, LO-
Protected relay output R1A, R1B, R1C 1 C/O |
|
| minimum switching current |
5 mA at 24 V DC for logic relay
|
|
| maximum switching current |
2 A at 250 V AC on inductive load cos phi = 0.4 L/R = 7 ms for logic relay
2 A at 30 V DC on inductive load cos phi = 0.4 L/R = 7 ms for logic relay 3 A at 250 V AC on resistive load cos phi = 1 L/R = 0 ms for logic relay 4 A at 30 V DC on resistive load cos phi = 1 L/R = 0 ms for logic relay |
|
| acceleration and deceleration ramps |
Linear from 0…999.9 s
S Linear from 0…999.9 s |
|
| braking to standstill |
By DC injection, <30 s
|
|
| protection type |
Line supply overvoltage
Line supply undervoltage Overcurrent between output phases and earth Overheating protection Short-circuit between motor phases Against input phase loss in three-phase Thermal motor protection via the drive by continuous calculation of I²t |
|
| frequency resolution |
Analog input: converter A/D, 10 bits
Display unit: 0.1 Hz |
|
| time constant |
20 ms +/- 1 ms for reference change
|
|
| operating position |
Vertical +/- 10 degree
|
|
| height |
151 mm
|
|
| width |
140 mm
|
|
| depth |
184 mm
|
|
| net weight |
1.8 kg
|
Only logged in customers who have purchased this product may leave a review.
Related products
-
Sale!
Variable Speed DrivesATV12P037M3 Variable speed drive ATV12 – 0.37kW – 0.55hp – 200..240V – 3ph – on base plate
Original price was: ₦391,500.00.₦313,200.00Current price is: ₦313,200.00. 7.5% VAT Add to basket -
Sale!
Variable Speed DrivesATV12H018M2 Variable speed drive ATV12 – 0.18kW – 0.25hp – 200..240V – 1ph
Original price was: ₦310,816.38.₦248,653.10Current price is: ₦248,653.10. 7.5% VAT Add to basket -
Sale!
Variable Speed DrivesATV12H018M3 Variable speed drive ATV12 – 0.18kW – 0.25hp – 200..240V – 3ph
Original price was: ₦318,691.38.₦254,953.10Current price is: ₦254,953.10. 7.5% VAT Add to basket -
Sale!
Variable Speed DrivesATV12HU30M3 Variable speed drive ATV12 – 3kW – 200..240V – 3ph – with heat sink
Original price was: ₦703,546.88.₦562,837.50Current price is: ₦562,837.50. 7.5% VAT Add to basket
Reviews
There are no reviews yet.